Husqvarna Pro 18 AWD manual Service Journal, Delivery Service, After the First 8 Hours

SERVICE JOURNAL

Action
Delivery Service
1. Fill the battery with battery acid and charge for four hours.
2. Fit the steering wheel, seat and, where applicable, other components.
3. Attach the cutting unit.
4. Adjust the cutting unit:
	Adjust the lifting springs (the ”weight” of the cutting unit should be
	12-15 kg, if a brush is to be used, set to maximum spring power).
	Adjust the cutting unit so that its rear edge is about 2-4 mm
	higher than its front edge.
	Adjust the cutting unit’s cutting height setting so that the cutting
	height limit is 5 mm above the unit frame at the lowest cutting
	height.
5. Check that the right amount of oil is in the engine and transmission.
6. Check and adjust the air pressure in the tyres (60 kPa, 0.6 bar).
7.	Connect the battery.
8. Fill the fuel tank and start the engine.
9. Check that the machine does not move in neutral.
10. Check:
	Driving forwards.
	Reversing.
	Engaging the blades.
	Safety switch in the seat.
	Safety switch for the lifting lever.
	The safety switch for the hydrostat pedals.
11. Check the engine speed: 2,900 ±75 rpm.
12. Bleed the hydraulic system, top up with oil if necessary.
13. Check the mounting bolts on the muffler.
14. Inform the customer about:
	The need and benefit of following the service schedule.	Delivery service has been carried
		out.
	The need and advantages of leaving the machine for service	No remaining notes.
	every 300 hours.
	The effects of service and maintaining a service journal on the	Certified:
	machine’s resale value.
	Application areas for BioClip.
15. Fill in the sales certificate, etc.
After the First 8 Hours		Date, mileage reading, stamp,
		signature
1.	Change engine oil.

72 – English