Husqvarna Pro 18 AWD manual Hydrostatic Cable with Linkage, Lubrication

LUBRICATION

Changing the Engine Oil

The engine oil should be changed the first time after 8 hours running time. It should then be changed after every 100 hours of running time. When operating with a heavy load or at high ambient temperatures, replace every 50 hours.

WARNING!

Engine oil can be very hot if it is drained directly after stopping the engine. Allow the engine to cool somewhat first.

1.Open the engine cover.

2.Place a container underneath the engine’s left oil drain plug.

3.Remove the dipstick. Remove the drain plug from the engine’s left side.

4.Let the oil run out into the container.

5.Then replace the oil drain plug and tighten it.

6.Replace the oil filter if necessary.

7.Fill with oil up to the FULL mark on the dipstick. Use engine oil as set out above.

8.Run the engine warm, then check that there is no leakage from the oil plug.

9.Check the oil level. Top up if necessary.

9.Hydrostatic Cable with Linkage

Remove the transmission cover, two screws.

Lubricate the joints and bearings on the left side with an oilcan.

Remove the rubber casing and lubricate the hydrostatic transmission cable with an oil can. Press the pedal a few times and lubricate again.

Replace the rubber cover.

Replace the transmission cover.

IMPORTANT INFORMATION

Used engine oil is a health hazard and must not be disposed of on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location.

Avoid skin contact; wash with soap and water in case of spills.

8009-529

6008-209

6020-024

60 – English