Husqvarna Pro 18 AWD manual Oil Filter, Change, Lubrication

LUBRICATION

13. Oil Filter, Change

WARNING!

Engine oil can be very hot if it is drained directly after stopping the engine. Allow the engine to cool somewhat first.

1.Open the engine cover.

2.Remove the oil filter. If necessary, use a filter remover.

3.Wipe new, clean engine oil onto the seal for the new filter.

4.Fit the filter by hand with + 3/4 turn.

5.Run the engine warm, then check that there are no leaks around the oil filter seal.

6.Check the oil level in the engine, top up if necessary. The oil filter holds 0.2 litres of oil.

IMPORTANT INFORMATION

Used engine or transmission oil is health- impairing and must not be disposed of in the ground or in nature.

Replaced filters must be handed in to the workshop or other allotted place for disposal.

Avoid skin contact; wash with soap and water in case of spills.

8009-161

14.Hydraulic Fluid Filter, Replacing Pro 18, Pro 18 AWD

1.Remove the oil filter. If necessary, use a filter remover.

2.Wipe new, clean engine oil onto the seal for the new filter.

3.Fit the filter by hand so it just touches + 3/4 turn.

4.Remove the transmission cover and fill the transmission’s oil tank, about 0.3 l oil. See ”11-12. Transmission Oil Level”. Be observant when running the engine as described below and fill so that the tank is not emptied.

5.Run the engine warm, manipulate the servo steering, and then check that there are no leaks around the oil filter seal.

6.Check the oil level in the transmission, top up if necessary. The oil filter holds 0.3 litres of oil.

7.Replace the transmission cover.

8009-507

62 – English