Check the engine’s cooling air intake | Husqvarna ProFlex 18

MAINTENANCE

Left-hand fender

Dismantle the screws (1 and 2), and lift off the fender.

Transmission cover

Undo the two screws (one on each side) and lift off the transmission cover.

Check the engine’s cooling air intake

Open the engine hood.

Check that the cooling intake is free from leaves, grass and dirt.

If the cooling intake is blocked this will interfere with the cooling of the engine, which can damage the engine.

Check the transmission’s air intake

Check that the transmission’s air intake in not blocked.

8009-166

6008-209

8009-152

6008-208

English – 23

Image 25

Husqvarna ProFlex 18 manual Check the engine’s cooling air intake, Check the transmission’s air intake, Left-hand fender

Contents

English Rider ProFlex Svenska Contents Dear customer InstructionTravel and transport on public roads Towing Good service Safety InstructionsSerial number Read the instructions Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Never run the machine in an enclosed area Transport Presentation PresentationLocation of the controls Choke lever Throttle controlSpeed limiter Speed of the machine is steplessly regulated Lift lever for cutting unit Cutting unit Parking brake Lever for adjustment of the cutting heightSeat Fuelling Before starting DrivingStarting the engine Driving the machine 6007-210 MAX Cutting tips Disengage lever Stopping the engine Maintenance schedule MaintenanceYear Year 100 300 Hours Before after Engine hood Dismantling of the machine hoodsNose Right-hand fender Check the transmission’s air intake Check the engine’s cooling air intakeLeft-hand fender Transmission cover Checking and adjustment of the steering wires Checking and adjusting the choke wire Checking and adjustment of the throttle wire Adjusting the hydrostatic wire Poorly adjusted brakes can result in reduced braking power Adjusting the brakesChecking the tyre pressure Replacing the air filter Cleaning the pulse air filter Replacement of the fuel filterChecking of the fuel pump’s air filter Procedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Take care. Risk of crushing injury Fitting the cutting unit Watch your fingers. Do not turn the blades or belt Belt diagramCheck that the belt is fitted around the tension roller Cutting height Parallelism Replacing the break-pin BioClip Placing in the service position Service position for the cutting unitReleasing from the service position Checking the blades Dismantling the cutting unit 8009-169 Dismantling the belt Removing the attachment frame Assembling the belt Replacing the cutting unit’s belts Belt replacement on BioClip Belt replacement on BioClip112 Cutting unit models Removal of BioClip plug Combi Lubrication Lubrication chart General Lubricating wiresPedal mechanism in frame tunnel Engine oil Chains in frame tunnel Transmission Gear lever Triangular link Throttle and choke wires, lever bearingsDriver’s seat Parking brake wire Oil filter, replacementBelt tensioner Transmission oil level Problem Procedure Trouble Shooting Schedule Storage ServiceWinter storage Wiring Diagram Rider ProFlex Technical Data Rear ejector BioClip Rear ejector Combi EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Pre-delivery service ServicejournalAfter first 8 hours Work done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00