MAINTENANCE
Adjusting the hydrostatic wire
The hydrostatic wire (on the left) is adjusted as follows:
1.Remove the transmission cover. Unscrew the two screws (one on each side) and lift off the transmission cover.
2.Separate the lower ball joint, which is secured with a spring clip.
3.Make sure the forward drive pedal is fully depressed.
4.Raise the arm as far as possible and check that the ball and socket of the lower ball joint match up.
5.Adjust the socket on the wire if required.
6.Reassemble the low ball joint.
7.Refit the ball joint spring clip.
26 – English
