Belt diagram | Husqvarna ProFlex 18 manual

MAINTENANCE

4.Slide in the unit so that the inner pins (B) bottom in the attachment frame’s groove.

5.Hook the rear end of the height adjustment arm

(E) in place:

Set the cutting height lever to the forward position. Release the pressure from the arm if necessary by lifting or pushin down on the front of the frame.

WARNING!

Watch your fingers. Do not turn the blades or belt.

6.Disconnect the belt adjuster spring and fit the belt over the front pulley. The new belt will be shorter. If necessary, fit a spanner over the centre bolt and turn the front pulley.

7.Hook on the belt adjuster’s spring again.

IMPORTANT INFORMATION

Check that the belt is fitted around the tension roller.

Belt diagram

1.Drive belt

2.Front pulley

3.Tension roller

4.Belt adjuster spring

8.Refit the nose.

8009-018

E

8009-168

8009-008

3

4

1

2

6016-105

English – 33

Image 35

Husqvarna ProFlex 18 manual Belt diagram, Watch your fingers. Do not turn the blades or belt

Contents

English Rider ProFlex Svenska Contents Towing InstructionDear customer Travel and transport on public roads Serial number Safety InstructionsGood service Read the instructions Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Never run the machine in an enclosed area Transport Location of the controls PresentationPresentation Speed of the machine is steplessly regulated Throttle controlChoke lever Speed limiter Lift lever for cutting unit Cutting unit Fuelling Lever for adjustment of the cutting heightParking brake Seat Starting the engine DrivingBefore starting Driving the machine 6007-210 MAX Cutting tips Disengage lever Stopping the engine Year MaintenanceMaintenance schedule Year 100 300 Hours Before after Right-hand fender Dismantling of the machine hoodsEngine hood Nose Transmission cover Check the engine’s cooling air intakeCheck the transmission’s air intake Left-hand fender Checking and adjustment of the steering wires Checking and adjusting the choke wire Checking and adjustment of the throttle wire Adjusting the hydrostatic wire Checking the tyre pressure Adjusting the brakesPoorly adjusted brakes can result in reduced braking power Replacing the air filter Checking of the fuel pump’s air filter Replacement of the fuel filterCleaning the pulse air filter Fitting the wrong spark plug type can damage the engine Check the level of the battery acidProcedures on contact with acid Inspecting the safety system Take care. Risk of crushing injury Fitting the cutting unit Check that the belt is fitted around the tension roller Belt diagramWatch your fingers. Do not turn the blades or belt Cutting height Parallelism Replacing the break-pin BioClip Checking the blades Service position for the cutting unitPlacing in the service position Releasing from the service position Dismantling the cutting unit 8009-169 Dismantling the belt Removing the attachment frame Assembling the belt Replacing the cutting unit’s belts Belt replacement on BioClip Belt replacement on BioClip112 Cutting unit models Removal of BioClip plug Combi Lubrication Lubrication chart Pedal mechanism in frame tunnel Lubricating wiresGeneral Engine oil Chains in frame tunnel Transmission Gear lever Driver’s seat Throttle and choke wires, lever bearingsTriangular link Transmission oil level Oil filter, replacementParking brake wire Belt tensioner Problem Procedure Trouble Shooting Schedule Winter storage ServiceStorage Wiring Diagram Rider ProFlex Technical Data Rear ejector BioClip Rear ejector Combi EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Work done ServicejournalPre-delivery service After first 8 hours Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00