Husqvarna ProFlex 18 manual Gear lever, Transmission

LUBRICATION

Check the engine oil level when the Rider is on level ground.

Raise the engine hood.

Take out the dipstick, wipe it clean and push it in again.

Do not screw in the dipstick.

Take out the dipstick again and read the oil level.

The oil level should be between the marks on the dipstick. If the level is close to the ”ADD” mark, top up with oil to the ”FULL” mark on the dipstick. Never fill above the ”FULL” mark.

Oil is added through the hole that the dipstick sits in.

Use SAE 30 or SAE 10W-30 grade engine oil, or 10W/40, class SC–SH (above 0° C/+32°F).

SAE 40 oil can be used above +20°C/+68°F.

Use SAE 5W-20 engine oil, class SC–SH (below 0° C/+32°F).

The engine holds 1.5 litres of oil, excluding the filter (1.7 litres including filter).

4. Gear lever

Remove the transmission cover by undoing the two screws.

Lubricate the joints and bearings on the left side using an oil can.

Push the rubber protector out of the way and lubricate the hydrostatic wire using an oil can. Press the pedal a few times and lubricate again.

Refit the rubber protector.

Refit the transmission cover.

5. Transmission

The oil should be changed by an authorised service workshop, and is described in the Workshop Ma- nual.

							8009-158
	ADD			FULL
ADD	FULL
							8009-159
	-20 C	-10 C	0 C	10 C	20 C	30 C	40 C
						SAE40

SAE30

SAE10W-30/SAE10W-40

SAE5W-20

-4 F 14 F 32 F 50 F 68 F 86 F 104 F

8009-140

6008-209

6020-024

English – 47