MAINTENANCE
The parts of the cutting unit
A cutting unit with a rear ejector has been used in the instructions below, however, the same procedure applies to other units if not otherwise stated.
The parts mentioned are:
A. | Catch | E. Height setting arm |
B. | Inner pin | F. Parallel strut |
C. | Hook guard | G. Lowest height setting stop |
D. | Handle |
|
Fitting the cutting unit
WARNING!
Take care. Risk of crushing injury.
Starting point for fitting the unit:
•Place the Rider on a level surface.
•Apply the brakes by pressing down the pedal and lock using the pushbutton.
•The attachment frame in the lowered position.
•The attachment frame locked with the hook guard and the catch (A) in the loaded position.
•Attachment frame mounted on cutting unit, see ”Removing the attachment frame”
1.Fit the unit in the attachment frame’s outer hooks.
2.Pull out the catch (A) and release the hook guard by sliding its handle (D) backwards.
3.Lift the attachment by pulling up the lever located on the driver’s
D E
C 
B 
A F G
A |
D |
A
32 – English
