Removal of BioClip plug Combi | Husqvarna ProFlex 18 manual

MAINTENANCE

Removal of BioClip plug (Combi)

To change a Combi unit from BioClip function to cutting unit with rear ejection, remove the BioClip plug located under the unit with three screws.

1.Put the unit in the service position, see ”Placing in the service position”.

2.Remove the three screws holding the BioClip plug, and remove the plug.

3.Tip: Fit three full-thread screws M8x15 mm in the screw holes to protect the threads.

4.Replace the unit in normal position.

Fit the BioClip plug in the reverse order.

Cutting unit models

The following versions of cutting units can be used on this type of machine:

Removal of BioClip plug	8009-289

Cutting unit with rear ejection 97 and 120	6017-162

BioClip 103	6017-108
BioClip 103
Combi 112	8009-288

English – 43

Image 45

Husqvarna ProFlex 18 manual Removal of BioClip plug Combi, Cutting unit models

Contents

English Rider ProFlex Svenska Contents Dear customer InstructionTravel and transport on public roads Towing Safety Instructions Good serviceSerial number Read the instructions Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Never run the machine in an enclosed area Transport Presentation PresentationLocation of the controls Choke lever Throttle controlSpeed limiter Speed of the machine is steplessly regulated Lift lever for cutting unit Cutting unit Parking brake Lever for adjustment of the cutting heightSeat Fuelling Driving Before startingStarting the engine Driving the machine 6007-210 MAX Cutting tips Disengage lever Stopping the engine Maintenance Maintenance scheduleYear Year 100 300 Hours Before after Engine hood Dismantling of the machine hoodsNose Right-hand fender Check the transmission’s air intake Check the engine’s cooling air intakeLeft-hand fender Transmission cover Checking and adjustment of the steering wires Checking and adjusting the choke wire Checking and adjustment of the throttle wire Adjusting the hydrostatic wire Adjusting the brakes Poorly adjusted brakes can result in reduced braking powerChecking the tyre pressure Replacing the air filter Replacement of the fuel filter Cleaning the pulse air filterChecking of the fuel pump’s air filter Check the level of the battery acid Procedures on contact with acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Take care. Risk of crushing injury Fitting the cutting unit Belt diagram Watch your fingers. Do not turn the blades or beltCheck that the belt is fitted around the tension roller Cutting height Parallelism Replacing the break-pin BioClip Placing in the service position Service position for the cutting unitReleasing from the service position Checking the blades Dismantling the cutting unit 8009-169 Dismantling the belt Removing the attachment frame Assembling the belt Replacing the cutting unit’s belts Belt replacement on BioClip Belt replacement on BioClip112 Cutting unit models Removal of BioClip plug Combi Lubrication Lubrication chart Lubricating wires GeneralPedal mechanism in frame tunnel Engine oil Chains in frame tunnel Transmission Gear lever Throttle and choke wires, lever bearings Triangular linkDriver’s seat Parking brake wire Oil filter, replacementBelt tensioner Transmission oil level Problem Procedure Trouble Shooting Schedule Service StorageWinter storage Wiring Diagram Rider ProFlex Technical Data Rear ejector BioClip Rear ejector Combi EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Pre-delivery service ServicejournalAfter first 8 hours Work done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00