Assembling the belt | Husqvarna ProFlex 18 specification

MAINTENANCE

Assembling the belt

1.Position the belt from the front and let the front end of the belt hang around the hook guard’s handle.

2.Fit the belt on the intermediate pulley and against the support wheel.

3.Fit the steering plate under the support wheel and tighten the bolts using two 13 mm spanners.

4. Hook on the spring for the blade brake.

The method of fitting the belt over the front pulley is described in steps 6–7 under ”Fitting the cutting unit”.

8009-009

6016-114

8009-005

40 – English

Image 42

Husqvarna ProFlex 18 manual Assembling the belt

Contents

Rider ProFlex English Svenska Contents Travel and transport on public roads InstructionDear customer Towing Safety Instructions Good serviceSerial number Explanation of Symbols Read the instructions Safety instructions General use Keep children away from the area to be mowed Driving on slopes Proceed as follows Maintenance Children Do not smoke when carrying out maintenance Transport Never run the machine in an enclosed area Presentation PresentationLocation of the controls Speed limiter Throttle controlChoke lever Speed of the machine is steplessly regulated Cutting unit Lift lever for cutting unit Seat Lever for adjustment of the cutting heightParking brake Fuelling Driving Before startingStarting the engine Driving the machine 6007-210 Cutting tips MAX Stopping the engine Disengage lever Maintenance Maintenance scheduleYear Hours Before after Year 100 300 Nose Dismantling of the machine hoodsEngine hood Right-hand fender Left-hand fender Check the engine’s cooling air intakeCheck the transmission’s air intake Transmission cover Checking and adjustment of the steering wires Checking and adjustment of the throttle wire Checking and adjusting the choke wire Adjusting the hydrostatic wire Adjusting the brakes Poorly adjusted brakes can result in reduced braking powerChecking the tyre pressure Replacing the air filter Replacement of the fuel filter Cleaning the pulse air filterChecking of the fuel pump’s air filter Check the level of the battery acid Procedures on contact with acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Fitting the cutting unit Take care. Risk of crushing injury Belt diagram Watch your fingers. Do not turn the blades or beltCheck that the belt is fitted around the tension roller Parallelism Cutting height Replacing the break-pin BioClip Releasing from the service position Service position for the cutting unitPlacing in the service position Checking the blades Dismantling the cutting unit 8009-169 Removing the attachment frame Dismantling the belt Assembling the belt Belt replacement on BioClip Replacing the cutting unit’s belts Belt replacement on BioClip112 Removal of BioClip plug Combi Cutting unit models Lubrication chart Lubrication Lubricating wires GeneralPedal mechanism in frame tunnel Chains in frame tunnel Engine oil Gear lever Transmission Throttle and choke wires, lever bearings Triangular linkDriver’s seat Belt tensioner Oil filter, replacementParking brake wire Transmission oil level Trouble Shooting Schedule Problem Procedure Service StorageWinter storage Wiring Diagram Technical Data Rider ProFlex Rear ejector Combi Rear ejector BioClip EU-DECLARATION of Conformity EU declaration of conformity Only applies to Europe After first 8 hours ServicejournalPre-delivery service Work done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00