Dismantling of the machine hoods, Nose | Husqvarna ProFlex 18

MAINTENANCE

Dismantling of the machine hoods

Engine hood

1.Tip up the seat.

2.Turn the main catch on top of the engine hood 1/4 turn anti-clockwise.

3.Lift up the engine hood.

If necessary the engine hood can be removed by taking out the hinge pins.

Nose

Loosen the quick-action lock and lift off the nose.

Right-hand fender

Dismantle the foot-plate (1), screws (2 and 3), and lift off the fender.

6020-014

8009-298

6016-106

2

1

3

6008-203

22 – English

Image 24

Husqvarna ProFlex 18 manual Dismantling of the machine hoods, Engine hood, Nose, Right-hand fender

Contents

Rider ProFlex English Svenska Contents Instruction Dear customerTravel and transport on public roads Towing Safety Instructions Good serviceSerial number Explanation of Symbols Read the instructions Safety instructions General use Keep children away from the area to be mowed Driving on slopes Proceed as follows Maintenance Children Do not smoke when carrying out maintenance Transport Never run the machine in an enclosed area Presentation PresentationLocation of the controls Throttle control Choke leverSpeed limiter Speed of the machine is steplessly regulated Cutting unit Lift lever for cutting unit Lever for adjustment of the cutting height Parking brakeSeat Fuelling Driving Before startingStarting the engine Driving the machine 6007-210 Cutting tips MAX Stopping the engine Disengage lever Maintenance Maintenance scheduleYear Hours Before after Year 100 300 Dismantling of the machine hoods Engine hoodNose Right-hand fender Check the engine’s cooling air intake Check the transmission’s air intakeLeft-hand fender Transmission cover Checking and adjustment of the steering wires Checking and adjustment of the throttle wire Checking and adjusting the choke wire Adjusting the hydrostatic wire Adjusting the brakes Poorly adjusted brakes can result in reduced braking powerChecking the tyre pressure Replacing the air filter Replacement of the fuel filter Cleaning the pulse air filterChecking of the fuel pump’s air filter Check the level of the battery acid Procedures on contact with acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Fitting the cutting unit Take care. Risk of crushing injury Belt diagram Watch your fingers. Do not turn the blades or beltCheck that the belt is fitted around the tension roller Parallelism Cutting height Replacing the break-pin BioClip Service position for the cutting unit Placing in the service positionReleasing from the service position Checking the blades Dismantling the cutting unit 8009-169 Removing the attachment frame Dismantling the belt Assembling the belt Belt replacement on BioClip Replacing the cutting unit’s belts Belt replacement on BioClip112 Removal of BioClip plug Combi Cutting unit models Lubrication chart Lubrication Lubricating wires GeneralPedal mechanism in frame tunnel Chains in frame tunnel Engine oil Gear lever Transmission Throttle and choke wires, lever bearings Triangular linkDriver’s seat Oil filter, replacement Parking brake wireBelt tensioner Transmission oil level Trouble Shooting Schedule Problem Procedure Service StorageWinter storage Wiring Diagram Technical Data Rider ProFlex Rear ejector Combi Rear ejector BioClip EU-DECLARATION of Conformity EU declaration of conformity Only applies to Europe Servicejournal Pre-delivery serviceAfter first 8 hours Work done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00