LUBRICATION
2. Chains in frame tunnel
Remove the cover from the frame tunnel, see step 1.
Lubricate the chains in the frame tunnel using an oil can or motorcycle chain spray.
Lubricate the shaft of the control wire pulleys with grease. Press the rollers to the side and brush the shaft with grease.
Refit the cover over the frame tunnel.
3. Engine oil
The oil should be changed for the first time after 8 hours of running time. Thereafter it should be changed every 100 hours of running time.
WARNING!
Engine oil can be very hot if it is drained off directly after the engine is stopped. Therefore allow the engine to cool down first.
1.Open the engine hood.
2.Place a container under the drain plug on the left side of the engine.
3.Remove the dip stick. Remove the drain plug on the
4.Let the oil run out into the receptacle.
5.Refit the drain plug and tighten it.
6.Replace the oil filter if necessary.
7.Top up with engine oil as described on the next page.
IMPORTANT INFORMATION
Used engine oil is hazardous to health
and must by law not be poured out on the ground or in the nature, but shall be handed in to a workshop or special environmental station. Avoid skin contact, wash with soap and water in the event of spillage.
46 – English
