Husqvarna ProFlex 18

English – 17

3. Select the required cutting height (1–7) with the

cutting height lever.

DRIVING

4. Push in the lock button on the lift lever and lower

down the cutting unit.

6007-210

6007-211

Contents

Main Page Operators Manual for Rider ProFlex 18 CONTENTS INSTRUCTION Dear customer Travel and transport on public roads Towing Intended use Good service Serial number 4 Read the instructions. N R EXPLANATION OF SYMBOLS Safety instructions General use Clear the area of objects before mowing. Never carry passengers. Read the operators manual before starting the machine. Page Be especially careful when driving on slopes. Mow upwards and downwards on slopes, not sideways. Driving on slopes Children Never allow children to operate the machine. Never fill the fuel tank indoors. Maintenance Do not smoke when carrying out maintenance. Transport Never run the machine in an enclosed area. Regularly clean grass, leaves and other debris from the machine. Presentation Location of the controls Throttle control Choke lever Speed limiter Cutting unit Lift lever for cutting unit Fuelling Seat Parking brake Lever for adjustment of the cutting height Before starting Starting the engine Driving the machine Page MAX 15 Cutting tips Stopping the engine Disengage lever Maintenance schedule Page Dismantling of the machine hoods Check the engines cooling air intake Check the transmissions air intake Checking and adjustment of the steering wires tightened up Checking and adjustment of the throttle wire Checking and adjusting the choke wire Adjusting the hydrostatic wire Adjusting the brakes B A Checking the tyre pressure Replacing the air filter Cleaning the pulse air filter Replacement of the fuel filter Checking of the fuel pumps air filter Check the level of the battery acid Ignition system Inspecting the safety system The parts of the cutting unit C F B A Belt diagram E Setting the parallelism and height for the cutting unit with rear ejector and BioClip unit Parallelism Cutting height Checking and adjustment of the cutting units ground pressure Replacing the break-pin (BioClip 103) 5 6 2B Service position for the cutting unit Placing in the service position Releasing from the service position Checking the blades Dismantling the cutting unit Page Dismantling the belt Removing the attachment frame Assembling the belt Replacing the cutting units belts C BioClip 103 Version 2 F B Page Combi 112 BioClip 103 Cutting unit with rear ejection 97 and 120 Removal of BioClip plug (Combi) Removal of BioClip plug Cutting unit models Page General Lubricating wires 1. Pedal mechanism in frame tunnel 2. Chains in frame tunnel 3. Engine oil 4. Gear lever 5. Transmission 6. Cutting unit 7. Triangular link 8. Drivers seat 9. Throttle and choke wires, lever bearings 10. Oil filter, replacement B 11. Belt tensioner A 12. Parking brake wire 13. Transmission oil level TROUBLE SHOOTING SCHEDULE Problem Procedure STORAGE Service Winter storage WIRING DIAGRAM TECHNICAL DATA Rider ProFlex 18 Cutting unit EU-DECLARATION OF CONFORMITY EU declaration of conformity Pre-delivery service After first 8 hours 25 hour service 50 hour service 100/200 hour service 300 hour service At least once a season