100/200 hour service | Husqvarna ProFlex 18 instruction

SERVICEJOURNAL

Work done

Date, mileage, stamp, sign

100/200 hour service

1.Change the engine oil. Change the oil filter every 200 hours.

2.Clean / replace the air filter pre-filter (oil-foam element).

3.Clean the paper air filter. Replace every 200 hours. (more regularly in dusty conditions)

4.Clean the engine cooling air intake and transmission air intake.

5.Clean the cooling flanges on the cylinders and cylinder head.

6.Check/adjust cutting height setting.

7.Check/adjust parking brake.

8.Inspect flame guard/spark arrestor (optional equipment)

9.Clean/replace spark plug.

10.Replace fuel filter in fuel line.

11.Clean the fuel pump air filter.

12.Clean pulse-air filter.

13.Check screw and nuts.

14.Check if it is necessary to change the oil in the K62 gearbox (every 500 hours).

English – 59

Image 61

Husqvarna ProFlex 18 manual 100/200 hour service

Contents

English Rider ProFlex Svenska Contents Dear customer InstructionTravel and transport on public roads Towing Good service Safety InstructionsSerial number Read the instructions Explanation of Symbols General use Safety instructions Keep children away from the area to be mowed Proceed as follows Driving on slopes Children Maintenance Do not smoke when carrying out maintenance Never run the machine in an enclosed area Transport Presentation PresentationLocation of the controls Choke lever Throttle controlSpeed limiter Speed of the machine is steplessly regulated Lift lever for cutting unit Cutting unit Parking brake Lever for adjustment of the cutting heightSeat Fuelling Before starting DrivingStarting the engine Driving the machine 6007-210 MAX Cutting tips Disengage lever Stopping the engine Maintenance schedule MaintenanceYear Year 100 300 Hours Before after Engine hood Dismantling of the machine hoodsNose Right-hand fender Check the transmission’s air intake Check the engine’s cooling air intakeLeft-hand fender Transmission cover Checking and adjustment of the steering wires Checking and adjusting the choke wire Checking and adjustment of the throttle wire Adjusting the hydrostatic wire Poorly adjusted brakes can result in reduced braking power Adjusting the brakesChecking the tyre pressure Replacing the air filter Cleaning the pulse air filter Replacement of the fuel filterChecking of the fuel pump’s air filter Procedures on contact with acid Check the level of the battery acidFitting the wrong spark plug type can damage the engine Inspecting the safety system Take care. Risk of crushing injury Fitting the cutting unit Watch your fingers. Do not turn the blades or belt Belt diagramCheck that the belt is fitted around the tension roller Cutting height Parallelism Replacing the break-pin BioClip Placing in the service position Service position for the cutting unitReleasing from the service position Checking the blades Dismantling the cutting unit 8009-169 Dismantling the belt Removing the attachment frame Assembling the belt Replacing the cutting unit’s belts Belt replacement on BioClip Belt replacement on BioClip112 Cutting unit models Removal of BioClip plug Combi Lubrication Lubrication chart General Lubricating wiresPedal mechanism in frame tunnel Engine oil Chains in frame tunnel Transmission Gear lever Triangular link Throttle and choke wires, lever bearingsDriver’s seat Parking brake wire Oil filter, replacementBelt tensioner Transmission oil level Problem Procedure Trouble Shooting Schedule Storage ServiceWinter storage Wiring Diagram Rider ProFlex Technical Data Rear ejector BioClip Rear ejector Combi EU declaration of conformity Only applies to Europe EU-DECLARATION of Conformity Pre-delivery service ServicejournalAfter first 8 hours Work done Hour service Servicejournal 100/200 hour service Servicejournal At least once a season Work done Date, mileage, stamp, sign Servicejournal ´+H%,¶6c¨ English 114 00