MAINTENANCE
6.Version 2:
Assembly: First fit the lower belt and then the upper belt.
Ensure the blades are positioned as set out in the diagram, at 90 degrees to each other, otherwise the belts must be adjusted. When the blade bearings are loose the belts can be moved around to the next tooth.
Tighten the nuts enough so that the bearings rest against the cutting hood but still can be moved.
Tension the belt by turning the eccentric adjuster on top of the cutting hood. Tighten the nut.
Tighten all nuts on the blade bearings.
7.Version 2:
When the belt can be moved 7 mm inwards using a force of 10 N the belt is adjusted correctly.
8.Version 1 and 2:
Fit the cover over the belts and refit the parallel strut and attachment frame.
Belt replacement on BioClip112
The BioClip 112 has
Belt change on cutting unit with side or rear ejection and Combi unit
On these cutting units with
1.Loosen the unit frame (1), the bolt on the parallelism arm (2) and the two bolts on the hood (3). Lift off the cutting unit’s hood.
2.Loosen the spring that tensions the
Reverse the procedure to fit the new belt.
IMPORTANT INFORMATION
On BioClip 103 units the belts must be set at 90° to each other. In all other cases the blades can collide and cause serious damage to the cutting unit.
3
3 
1
2
42 – English
