IBM 6274, 2283 manual Connecting cables, USB connectors

•Avoid the use of extension cords. Whenever possible, plug the computer power cord directly into an electrical outlet.

•Keep power cords and cables neatly routed away from walkways and other areas where they might be accidentally dislodged.

Connecting cables

Read the following before connecting cables:

•Connect all device cables before plugging any power cords into an electrical outlet.

•Connect the power adapter cord to the computer 10 (see Figure 1 on page 9) and to the other devices before plugging them into an electrical outlet.

Important

If your computer is being connected to an Ethernet network, a Category 5 Ethernet cable must be used for operation of the system within FCC Class A limits.

USB connectors

There are six USB connectors on your computer (see Figure 1 on page 9): four at the rear 9 and two on the top side 5 of the monitor.

If your computer comes with a USB keyboard and mouse, plug them into the USB ports at the rear of the computer near the power cord connector. These cables can be relocated to other USB connectors at a later time if desired.

If your computer comes with an IBM Dual Wireless Receiver, plug the receiver into one of the USB connectors at the rear of the computer. The Rapid Access Wireless Keyboard and the ScrollPoint Wireless Mouse operate with this receiver.

Notes:

1.Cable connectors from USB devices are keyed so that they cannot be connected incorrectly.

2.Do not place the IBM Dual Wireless Receiver on top of the power supply.

8User Guide