1. Printer Settings (15 ppm copier)

Menu

Item

Available settings

Remarks

number

 

 

 

 

 

 

 

P71

Receive dump mode

(1) OK

 

 

The data that the printer receives for debugging

 

 

 

programs and files is turned into hexadecimal code

 

 

 

and printed out. If “OK” (setting: 1) is selected here,

 

 

 

this receive dump mode will be activated. The

 

 

 

receive dump mode will be canceled under the

 

 

 

following circumstances:

 

 

 

• The Start key is pressed in the printer mode.

 

 

 

• A force-print time-out occurs.

 

 

 

 

 

 

P72

Printer reset

(1) OK

 

 

Resets the Printer Board only even without turning

 

 

 

the power to the machine OFF.

 

 

 

 

 

 

P73

Resource protect mode

(1) Off

At least 16 MB of additional memory

 

Protects the resource data of fonts and macros

(2) Permanent

(option) must be installed.

 

downloaded through PCL6 and, even if the emula-

(3) Permanent/Temporary

 

 

tion protocol is switched, the PCL resource will be

 

 

 

saved in the printer’s memory. If “Permanent”

 

 

 

(setting: 2) is selected here, temporary resources

 

 

 

will not be saved. If, however, “Permanent/Tempo-

 

 

 

rary” (setting: 3) is selected, temporary resources

 

 

 

will also be saved.

 

 

 

Permanent/Temporary

 

 

 

 

 

 

P74

Auto Continue ON/OFF

(1) On

 

 

If one of the following error messages appears and

(2) Off

 

 

“On” has been selected here, the error state will be

 

 

 

released and the printing operation will be restarted

 

 

 

automatically after a specified amount of time.

 

 

 

“Memory overflow (error code : E70)”

 

 

 

“Print overrun (error code : E80)”

 

 

 

 

 

 

P75

Recovery time for Auto Continue

000 - 495 (sec.)

 

 

Sets the amount of time before Auto Continue

 

 

 

engages when “On” (setting: 1) is selected under the

 

 

 

“Auto Continue ON/OFF” setting (menu: P74). If

 

 

 

“000” seconds is selected here, Auto Continue will

 

 

 

engage immediately after the error.

 

 

 

 

 

 

P76

Service Rep Status Page print out

– – –

Print out will begin as soon as the

 

Prints out a Status Page for use by your service

 

corresponding menu number is

 

representative.

 

displayed and the Enter key pressed.

 

 

 

 

1-6

Page 11
Image 11
IBM Printing System manual Receive dump mode, Printer reset, Resource protect mode, Auto Continue ON/OFF