IBM Printing System Wide A4 ON/OFF, Printing orientation parallel interface, Smoothing ON/OFF

1. Printer Settings (15 ppm copier)

Menu	Item		Available settings	Remarks
number
P47	Wide A4 ON/OFF	(1)	On
	Increases the printing area on A4 size paper.	(2) Off
P48	Printing orientation (parallel interface)	(1)	Portrait
		(2)	Landscape
P49	Printing orientation (network interface)	(1)	Portrait	Available only when the Network
		(2)	Landscape	Card is installed.
P50	Smoothing ON/OFF	(1)	On
	Allows a printing resolution of an interpolated 2400	(2) Off
	dpi x 600 dpi through the smoothing process.
P51	Draft Mode ON/OFF	(1)	On
	Allows printing in a toner-saving mode. This mode is	(2) Off
	especially suited for test pages, etc., where high
	printing quality is not required.
P52	Printing resolution	(1)	300 dpi
		(2)	600 dpi
P55	RAM disk ON/OFF	(1)	On	At least 16 MB of additional memory
		(2) Off		(option) must be installed.
P56	RAM disk size	01 - 99 (MBytes)
	Sets the amount of memory that will be used as a
	RAM disk. The maximum size that can be selected
	is the total amount of memory installed minus the
	amount used by the system (9 MB).
P61	A4 & Letter usage ON/OFF	(1)	On
	Allows both A4 and letter size paper to be utilized as	(2) Off
	though they are the same size.
P62	Bypass mode	(1)	Cassette
	If “First” (setting: 2) is selected here and there is	(2)	First
	paper set in the Multi-Bypass, paper feed will be
	accomplished from the Multi-Bypass.
P70	Force-print time-out	000 - 495 (sec.)
	If “000” seconds is selected here, successive pages
	will not be printed until they are manually force-
	printed (by pressing the Start key in the printer
	mode).

1-5