Installation
2.2ON/OFF - Standby mode
Note ! At first time turn on see paragraph 4.1.
A single press on the STBY button switches the system ON and the following status displays are shown:
Autopilot model
Software version
SimNet no.
Simrad
AP26
SW 1.0.00 HW rev. 00 Sn xxxxxx
Software release Hardware revision
Autopilot computer model
Software version
Power board revision Main board revision
Simrad
AC20
SW 1.0.00
P00 M00 S000 Software release 
Self check
SW and HW revisions shown are examples only.
After approximately 5 seconds, the system is operative and the unit that was turned on will show the Standby mode display. Other units in a multistation system will display "Inactive". Control is transferred to any single unit by pressing its’ STBY button.
The main Standby mode display shows the current heading.
Alternatively, the Standby mode display can show the following information by a long press on the TURN/DODGE/INFO button:
− Standby mode
− Current heading 345°M
− Compass source: Rate compass
− Rudder angle =00°. Refer to INFO menu, page 46.
20221586B | 17 |
