Simrad AP26, AP27 manual Linear Drive Units

Installation

LINEAR DRIVE UNITS

MODEL	MOTOR	AUTO-	MAX	PEAK	MAX	HARD-	PWR.	TILLER
	VOLTS	PILOT	STROKE	THRUST	RUDDER	OVER	CON-	ARM
		COM-	mm (in.)	kg (lb.)	TORQUE	TIME	SUMP.	mm
		PUTER			Nm	sec.		(in.)
					(lb.in.)	(30% load)
MLD200	12V	AC10	300 (11,8)	200	490	15	1,5-6 A	263
				(440)	(4350)			(10,4)
HLD350	12V	AC10	200 (7,9)	350	610	12	2,5-8 A	175
				(770)	(5400)			(6,9)
HLD2000L	12V	AC20	340 (13,4)	500	1460 (12850)	19	3-10 A	298
				(1100)				(11,7)
HLD2000D	24V	AC20	200 (7,9)	1050	1800	11	3-10 A	175
				(2310)	(15900)			(6,9)
HLD2000LD	24V	AC20	340 (13,4)	1050	3180	19	3-10 A	298
				(2310)	(28000)			(11,7)
MSD50*	12V	AC10	190 (7,5)	60	–	15	0,8-2 A	–
				(132)

Steering gear interface: Connects to quadrant or tiller.

*For stern drive power assisted steering only.

1.The motor voltage is stepped down by the autopilot computer when operating from 24V or 32V mains.

2.The specified autopilot computer is necessary to achieve max drive unit capacity.

3.Recommended operational thrust or torque is 70% of listed peak value.

4.Typical average power consumption is 40% of listed maximum value.

20221586B 59