![](/images/new-backgrounds/1303311/30331139x1.webp)
Simrad AP26 and AP27 Autopilots
A long press
Note ! In an emergency, it is possible, on a multistation system, to turn OFF the system at any control unit by pressing the STBY button for
STBY mode is the mode that is used when steering the boat at the helm.
Flashing course knob icon
When the course knob and the PORT/STBD buttons are used for settings etc., an icon will flash on the screen to tell that no course changes can be made unless you press the AUTO button.
Alarms
In the event there is an audible alarm with explaining text on the control unit, refer to section 6 Trouble shooting.
2.3AP26 and AP27 with MSD50 Stern Drive
unit
Note ! The information in section 2.3 only applies if your autopilot is driving a Simrad MSD50 Stern Drive.
The MSD50 Stern drive unit has a relative feedback signal which needs a zero point setting after the autopilot has been turned on. Refer to the MSD50 manual for further information.
Zero point setting
Note ! If you do not need a rudder angle display when leaving the dock, just steer the boat manually on a straight course and press the AUTO button. The zero point is then set automatically.
If you prefer to use the rudder angle display when leaving the dock, proceed as follows:
After turn on the rudder angle display will alternate between 10 degrees port and starboard to indicate that the "rudder" zero point need be set.
18 | 20221586B |