Simrad AP26 and AP27 Autopilots
the bolt. Secure the feedback rod to the retainer plate using the two washers and the cap nut provided. Adjust the location of the LF3000 Linear Feedback to allow full travel of the hydraulic cylinder without causing the retainer plate to hit the end of the cylinder. Check that the outboard motor can be tilted freely. Tighten all nuts and the mounting bracket.
Turn the helm slowly by hand to the stop on either side, check that the rod does not bind up in any direction. Make a “drip nose” (c) on the cable to the unit and clamp the cable to allow full engine movement to port and starboard.
MOUNTING BRACKET
CLAMPS (2 HALVES)ALLEN HEX SCREWS (2)
FLAT WASHERS (2)
RETAINER PLATE
(END VIEW)
CYLINDER |
| |
LOCK NUT | LF3000 | |
FLAT WASHERS (2) | ||
LINEAR FEEDBACK | ||
LF3000 |
| |
BRACKET |
|
a
b
Figure | c |
80 | 20221586B |
