Simrad AP27, AP26 manual Cable pairs Color code Signal, System

Simrad AP26 and AP27 Autopilots

both ends are available in 1, 5 and 10 m length. For cable extension a Robnet2 T-Joiner is required.

When installing a system, try to minimize the total cable length by connecting all Robnet2 units to the nearest available Robnet2 connector.

Total length of Robnet2 cable installed in a system should not exceed 50 m (165').

Examples of interconnecting Robnet2 units:

AUTOPILOT	CONTROL		CONTROL			AP27	COMPASS
					CONTROL
COMPUTER		UNIT		UNIT
						UNIT

T-joiner

Figure 3-9 Interconnecting Robnet2 units

ARobnet2 T-Joiner P/N 24005662 is available to make the Robnet2 interconnection more simple by reducing the number of cables or extend cables when necessary.

See table for pin configuration and colour code of the network cable.

Cable pairs	Color code	Signal
1. pair	Pink	V SYSTEM+
	Grey	V SYSTEM–
2. pair	Brown	Bus–
	White	Bus+
	Yellow	On - Off

Figure 3-10 Robnet2 Connector

Note ! The connectors are weather proof according to IP65, when properly installed. All unused Robnet2 connectors must be fitted with the plastic cap to protect them against dirt and moisture.

64 20221586B