Simrad AP26 and AP27 Autopilots

Regain manual steering by pressing the STBY button

Setting the waypoint arrival circle

For route navigation it is recommended to use automatic waypoint shift/change at a set waypoint arrival circle.

The arrival circle should be adjusted according to boat speed. The higher speed, the wider circle. The intention is to make the autopilot start the heading change in due time to make a smooth turn onto the next leg.

The figure below may be used to select the appropriate waypoint circle.

Example: With the speed of 20 knots you should use a waypoint circle with radius 0.09 nm.

Note ! The distance between any waypoints in a route must not be smaller than the radius of the waypoint arrival circle when using automatic waypoint shift.

30

20221586B

Page 32
Image 32
Simrad AP27, AP26 manual Setting the waypoint arrival circle