Installation
Optional bracket mounting
•Locate the cradle on the mounting site and mark the 4 holes for the fixing screws on the mounting surface.
•Drill the 4 mounting holes and screw the cradle to the mounting surface.
•Use the supplied screws to fasten the control unit to the left and right brackets.
•Apply the front panel corners.
•Use the two locking knobs to assemble the cradle with the left and right brackets and adjust the control head to best viewing angle.
•Connect the Robnet2 cable(s) to the control unit connector(s)
(See note on page 64).
Figure 3-8 AP26 Bracket mounting
3.12ROBNET2 network cables
As Robnet2 units have two Robnet2 connectors (blue) they can be used as "jack points" for further expansion of the system. There are no dedicated "in" or "out" connectors. You may connect the cables to any available Robnet2 connector (blue) on the specific unit. The Robnet2 connectors have a locking mechanism for extra safety.
Caution ! Do not mix the blue Robnet2 cables with the yellow SimNet cables.
The 15 m cable to the autopilot computer has a connector only at the control unit end. Robnet2 cables with 5 pin male connector at
20221586B | 63 |
