Simrad AP26, AP27 R3000X Remote Control NFU, JS10 Joystick NFU, Initial mode 1st press 2nd press

Installation

2.6R3000X Remote Control (NFU)

SIMRAD

STBY-AUTO

Simrad R3000X

Notes !

Push button for Port and Stbd commands

STBY/automatic.

Automatic modes are active when the lamp is lit.

In STANDBY mode, the rudder will move as long as the Port or Stbd button is pressed.

In AUTO mode and Wind modes the set course or set wind angle will change 1° each time the button is pressed.

Note!

If you keep the button pressed, it will automatically change the setting in increments of 3° per second.

Mode changes are as per table below.

Initial mode	1st press	2nd press
STBY	AUTO	STBY
AUTO	STBY	AUTO
NAV	STBY	AUTO 1)3)
STBY	WIND	STBY 2)
AUTO	STBY	WIND 2)
WIND	STBY	WIND 2)
WINDN	STBY	WIND 3)

1.When NAV mode is selected in User Setup

2.When WIND mode is selected in User Setup

3.NAV and WINDN modes can only be entered from the Control unit because you have to accept the prompt displays.

2.7JS10 Joystick (NFU)

The principle is similar to that of R3000X Remote Control (see above). The rudder will move as long as the lever is offset to Port or Starboard. JS10 has no mode change feature.

Note ! When a NFU steering lever or a remote control is operated, the control units and FU25 become "Inactive".

20221586B 21