Simrad AP26, AP27 manual Follow-Up steering FU

Installation

Use the wheel to bring the "rudder" to midship position. Turn the wheel from lock to lock (H.O. to H.O.) and count the exact number of turns. Then start from one lock position and turn the half number of turns.

Press AUTO and then STBY. The zero point is now set and the display will show:

Follow the operating instructions on the following pages. There is no further need for zero point settings until next time you turn the autopilot on.

2.4Follow-Up steering (FU)

In the Follow-Up steering mode the course knob may be used to set rudder commands. The commanded rudder angle is shown on the display and the rudder will move to the commanded angle and stop.

Press both buttons	Use course
simultaneously to	knob to	Commanded rudder angle 10° to
activate Follow-	command
		port. Rudder angle: 4° to port
Up	rudder angle
		and moving.

Return to manual control in Standby by pressing the STBY button

WARNING ! While in Follow-up mode you cannot take manual control of the wheel.

20221586B 19