2. Printer Settings (20 ppm copier)
Item No. | Item | Display message | Available settings | Remarks |
|
|
|
|
|
55 | Receive dump mode | Print | OK |
|
| The data that the printer receives for |
|
|
|
| debugging programs and files is turned into |
|
|
|
| hexadecimal code and printed out. If “OK” is |
|
|
|
| selected here, this receive dump mode will |
|
|
|
| be activated. The receive dump mode will be |
|
|
|
| canceled under the following circumstances: |
|
|
|
| • Form feed is initiated (by selecting the |
|
|
|
| “GO” command in the printer mode and |
|
|
|
| then pressing the Enter key). |
|
|
|
| • A |
|
|
|
|
|
|
|
|
56 | Printer reset | Printer Reset | OK |
|
| Resets the Printer Board only even without |
|
|
|
| turning the power to the machine OFF. |
|
|
|
|
|
|
|
|
57 | Resource protect mode | Resource pro. | Off, Permanent, | At least 16 MB of additional |
| Protects the resource data of fonts and |
| Per/Temp | memory (option) must be installed. |
| macros downloaded through PCL6 and, |
|
|
|
| even if the emulation protocol is switched, |
|
|
|
| the PCL resource will be saved in the |
|
|
|
| printer’s memory. If “Permanent” is selected |
|
|
|
| here, temporary resources will not be saved. |
|
|
|
| If, however, “Per/Temp” is selected, |
|
|
|
| temporary resources will also be saved. |
|
|
|
|
|
|
|
|
58 | Auto Continue ON/OFF | Auto Continue | On, Off |
|
| If one of the following error messages |
|
|
|
| appears and “On” has been selected here, |
|
|
|
| the error state will be released and the |
|
|
|
| printing operation will be restarted |
|
|
|
| automatically after a specified amount of |
|
|
|
| time. |
|
|
|
| “Memory overflow” |
|
|
|
| “Print overrun” |
|
|
|
|
|
|
|
|
59 | Recovery time for Auto Continue | Change # | 000 - 495 (sec.) | Displayed only when “On” is |
| Sets the amount of time before Auto |
|
| selected under the “Auto Continue |
| Continue engages when “On” is selected |
|
| ON/OFF” setting (item No.: 58). |
| under the “Auto Continue ON/OFF” setting |
|
|
|
| (item No.: 58). If “000” seconds is selected |
|
|
|
| here, Auto Continue will engage immediately |
|
|
|
| after the error. |
|
|
|
|
|
|
|
|
60 | Service Rep Status Page print out | Print Status page | No, Print |
|
| Prints out a Status Page for use by your |
|
|
|
| service representative. |
|
|
|
|
|
|
|
|
