IBM REDP-4372-00 manual Service Pack 2 unpack and integration in progress

Draft Document for Review November 15, 2007 3:27 pm 4372ch02.fm

2.Locate your local copy of the Windows XP source files that were created in 2.2.1, “Copying the media files” on page 19.

3.Open a command prompt (start → run → cmd) and go to the folder where you copied Service Pack 2. Type the command as shown in Example 2-2

Example 2-2 Unpacking and integrating Service Pack 2 into Windows XP

x:\winXPimg\SP2\WindowsXP-KB835935-SP2-ENU /integrate:X:\winXpimg\i386

After issuing the command above you should see the files being extracted and then integrated into the Windows XP files as shown in Figure 2-2

Figure 2-2 Service Pack 2 unpack and integration in progress

After the extraction and integration is completed you should get a confirmation that Windows XP Service Pack2 has now been slipstreamed into your original Windows XP files as shown in Figure 2-3

Figure 2-3 SP 2 integrated successfully

At this point the Service Pack 2 is integrated into the base code. This process is pretty much the same for all Windows operating system variants.

Chapter 2. First-time installations 21