IBM Safenet/400 manual Setting up TCP/IP Address Controls, Turning on TCP/IP Address Checking

Setting up TCP/IP Address Controls

SafeNet/400 allows you to specify which client IP addresses are either accepted or rejected by the Telnet and the FTP Servers.

Turning on TCP/IP Address Checking

To set-up and turn on TCP/IP address checking for the FTP Server and Rexec Server

1.Type WRKTCPIPA *FTPSERVER then ENTER

2.Add the IP addresses to the Control Table

3.Type CHGFTPSET then press F4

4.Change Server Source limit by IP Address? to *YES then ENTER

5.Use WRKSRV command and set the *FTPSERVER and/or *REXEC Server exit point to level 3 or 4.

To set-up and turn on TCP/IP address checking for the FTP Client:

1.Type WRKTCPIPA *FTPCLIENT then ENTER

2.Add the IP addresses to the Control Table

3.Type CHGFTPSET then press F4

4.Change Client Target limit by IP Address? to *YES then ENTER

5.Use WRKSRV command and set the *FTPCLIENT exit point to level 3 or 4.

To set-up and turn on TCP/IP address checking for TELNET:

1.Type WRKTCPIPA *TELNET then ENTER

2.Add the IP addresses to the Control Table

3.Type WRKSRV

4.Change the *TELNETON point to Level 3

	SafeNet/400 Reference Guide
3.6	♥ Copyright 2008 MP Associates of Westchester, Inc.
	V8.50 - May 2008