Icom IC-R20 instruction manual Memory programming, Setting frequency, Selecting a memory channel

[Using the keypad]

➥Enter the desired frequency via the keypad.

•Direct input can be set until 1 kHz digit, rotate [R-DIAL]to set below 1 kHz frequency after set tuning steps, if necessary. (See p. 14 for setting the tuning step.)

•Pushing [VFO MHz] omits the entry of 100 kHz and below, when you want to edit to these digits “0.”

•Push [DUALWATCH] to cancel the entry.

QUICK REFERENCE GUIDE

■Memory programming

The IC-R20 has a total of 1250 memory channels (including 200 auto write channels and 50 scan edges) for storing often used receive frequency, mode, etc.

1. Setting frequency

In VFO mode, set the desired receive frequency mode.

•When “µ ” indicator is displayed, push [VFO MHz] to select the VFO mode.

Quick reference guide

DUALWATCH	MAIN/SUB		POWER		VFO
					MHz
BAND	VFO	MODE	MR	1	2	3
	MHz	SCAN	S.MW
1	2	3	SCOPE
4	5	6	0 AFC	4	5	6	0 AFC
7	8	9	LOCK

2.Selecting a memory channel

Push [MR S.MW] for 1 sec., then rotate [R-DIAL]to select the de- sired memory channel.

Top

DUALWATCH MAIN/SUB POWER

REC 7 8 9 LOCK

Front

5.Receive mode selection

➥ Push [MODE SCAN] several

times to select the desired re-	DUALWATCH	MAIN/SUB		POWER
		VFO	MODE	MR	MODE
ceive mode.	BAND
		MHz	SCAN	S.MW	SCAN
	1	2	3	SCOPE
• FM, WFM, AM, LSB, USB and
	4	5	6	0 AFC
CW are available.
	7	8	9
				LOCK
				REC	Front

• “µ ” indicator blinks.		VFO	MODE	MR	MR
	BAND
		MHz	SCAN	S.MW	S.MW
FM	1	2	3	SCOPE

146..010µ 999	4	5	6	0 AFC
-BANK-:----	7	8	9	LOCK
-BNAME:				REC	Front
-MNAME:

-SKIP-:OFF >CLEAR

3. Writing a memory channel

Push [MR S.MW] for 1 sec. until 3 beeps sound.

•Memory channel number automatically increases when continuing to push [MR S.MW] after programming.

VI