Icom IC-R20 instruction manual Memory clearing, Push MR S.MW for 1 sec. to clear the contents

■Memory clearing

Contents of programmed memories can be cleared (blanked), if desired.

qPush [MR S.MW] for 1 sec. to select the select memory write condition.

•1 short and 1 long beeps sound.

•“µ ” indicator blinks.

•Do not hold [MR S.MW] for more than 2 sec. otherwise the memory contents will be copied to VFO.

wRotate [R-DIAL]to select the desired memory channel to be cleared.

eWhile pushing [8 SET], rotate [R-DIAL]to select “CLEAR.”

•“CLEAR” item can also be selected by pushing [8 SET] several times.

[R-DIAL]	FM
	144..010µ 028
	-BANK-:----
	-BNAME:
	-MNAME:
	-SKIP-:OFF
	>CLEAR
	SET
MR	After 8 is pushed
S.MW
	several times.
SET	-BANK-:----
8
	-BNAME:
	-MNAME:
	-SKIP-:OFF
	>CLEAR

MEMORY CHANNELS 6

rPush [MR S.MW] for 1 sec. to clear the contents.

•3 beeps sound.

•The cleared channel changes to blank channel

•Return to the select memory write condition.— “µ ” indicator blinks. Push [DUALWATCH] to exit the select memory write con- dition, then push [VFO MHz] to return to VFO mode.

Push	MR	for 1 sec.	6
	S.MW
FM		FM
144..010µ 028		144..010µ 028
-BANK-:----		-BANK-:----
-BNAME:		-BNAME:
-MNAME:		-MNAME:
-SKIP-:OFF		-SKIP-:OFF
>CLEAR		>CLEAR

NOTE: Be careful!— the contents of cleared memories CANNOT be recalled even in bank channel operation.

32