Icom IC-R20 instruction manual Scan edges programming

SCAN OPERATION 7

■Scan edges programming

Scan edges can be programmed in the same manner as memory channels. Scan edges are programmed into scan edges, 00A/00B to 24A/24B, in memory channels.

qPush [VFO MHz] to select VFO mode. wSet the desired frequency:

➥Select the desired band with [BAND].

➥Set the desired frequency with [R-DIAL].

➥Set other data (e.g. offset frequency, duplex direction, tone

squelch, etc.), if desired.

ePush [MR S.MW] for 1 sec. to select select memory write condition.

tPush [MR S.MW] for 1 sec.

•3 beeps sound

•The other scan edge channel “B,” 00B to 24B, automatically se- lected when continuing to push [MR S.MW] after programming.

yTo program a frequency for the other pair of scan edges, 00B to 24B, repeat steps w and r.

•If the same frequency is programmed into a pair of scan edges, programmed scan will not function.

7

[R-DIAL]

•1 short and 1 long beeps sound.

•“µ ” indicator blinks.

rRotate [R-DIAL]to select the desired programmed scan

edge channel from 00A to 24A.

MR

S.MW

[EXAMPLE]: Programming 145.300 MHz into scan edges 03A.

		Push	MR	for 1 sec.	Rotate		Push
			S.MW
-DUP TSQL		AFC		FM		FM
MODE	FM ANL			146..010µ 001		----------------
145 300						.	µ 03A
				-BANK-:----		-BANK-:----
		PSKIP		-BNAME:		-BNAME:
				-MNAME:		-MNAME:
√	µ	001
				-SKIP-:OFF		-SKIP-:OFF
				>CLEAR		>CLEAR

MR	for 1 sec.
S.MW
	-DUP TSQL		AFC		-DUP TSQL	AFC
	MODE	FM ANL		MODE FM ANL
	145 300				145 300
			PSKIP			PSKIP
	√	µ	03A	√	µ	020

36