• Automatic recording

The IC-R20 has an automatic recording function. When this function is activated, the receiver will record automatically when a receiving signal appears and pause when the signal disappears. This function is very useful when you want to store an uncontinuous signal.

qPush [ REC] for 1 sec. to enter the recording set mode. wRotate [R-DIAL]to select “REC REMOTE,” then push

[ REC].

*****-REC--*****

REC-REMOTE

----------------

----------------

-QUALITY

-OFF

>REC-REMOTE

>ON

-ALL-DELETE

 

OTHER FUNCTIONS 11

• Erasing recorded audio

NOTE: The IC recorder can erase all the tracks at the

same time, but cannot erase each track independently.

Only using the optional CS-R20 CLONING SOFTWARE can store the recorded audio into a PC or erase independently.

qPush [ REC] for 1 sec. to enter the recording set mode. wRotate [R-DIAL]to select “ALL DELETE,” then push

[ REC].

*****-REC--*****

ALL-DELETE

----------------

----------------

-QUALITY

-NO

-REC-REMOTE

>YES

>ALL-DELETE

 

eRotate [R-DIAL]to select the setting, then push [ REC]. rPush [DUALWATCH] to exit the recording set mode. tPush [ REC] to activate.

NOTE: Before using this function, verify the squelch set-

ting as close level when no signal is received. Otherwise this function will not pause even when signal disappears.

eRotate [R-DIAL]to select “YES” if you want to delete all

11

 

tracks, then push [ REC].

 

• After deleting, the receiver returns to normal operating mode.

NOTE: The optional CS-R20 can perform the storing the

recorded contents into PC, erasing them independently or

editing their information. The CS-R20 cannot playback the

stored contents on the PC. The recorded contents can be played back on the IC-R20 only.

66

Page 79
Image 79
Icom IC-R20 Automatic recording, Erasing recorded audio, Rec, Same time, but cannot erase each track independently