InFocus 570, 560 manual Remote Control Programmer Kit, Usage Guidelines, If You Need Assistance

Introduction

Remote Control Programmer Kit

The Remote Control Programmer Kit that was shipped with your LitePro allows you to program the LitePro’s remote control to perform up to four different operations on your computer. Refer to the Remote Control Programmer User’s Guide for more information.

Usage Guidelines

•Do not look directly into the projection lens when the LitePro is turned on! The bright light may harm your eyes.

•The back of the LitePro can be very hot to the touch after use. Use extreme care or let it cool before lifting it.

•Do not block the grills at the back of the LitePro. Restricting the air flow through the LitePro can cause it to overheat and turn off.

•Handle the LitePro as you would any product with glass components. Be especially careful not to drop it.

•Avoid leaving the LitePro in direct sunlight or extreme cold for extended periods of time. If this happens, allow it to reach room temperature before use.

•Transport the LitePro in the original shipping box or approved hard case (see your In Focus dealer for details on approved hard cases).

If You Need Assistance

The first place to look for help is in this manual. Be sure to check the troubleshooting guidelines in “Troubleshooting” starting on page 47.

If this manual does not answer your question, call your In Focus dealer. You can also call In Focus Technical Support directly at 1-800-294-6400. Call between 6 a.m. and 5 p.m. PST, Monday through Friday. In Europe, call In Focus in The Netherlands at (31) 23 5623200.

Your LitePro is backed by a limited one-year warranty. The details of the warranty are printed at the back of this manual.

LitePro 560/570 User’s Guide 3