Using the LitePro
Switching to the Spare Lamp
The LitePro was shipped with two projection lamps. To avoid breaking during shipping, they are not installed at the factory. You must install them before you can use the LitePro. Refer to the “Read Me First” document that was shipped with your LitePro for instructions. “Replacing the Projection Lamps” on page 40 also describes this procedure.
When both lamps are installed in the LitePro, only one is used at a time. The other is available as a spare for when the active lamp fails. The average lamp life is about 50 hours.
To switch to the spare lamp:
•Gently slide the lamp changer knob to the other side of the projector as shown here.
Figure 13. Switching to the Spare Lamp
When switching lamps, be careful not to touch the exhaust grill on the door. This area is very hot when the projector is operating.
LitePro 560/570 User’s Guide | 19 |
