Sync, Up/Down, Left/Right | InFocus 560, 570 manual

Using the LitePro

Sync

The LitePro adjusts signal synchronization automatically for most computers. But if the projected computer image looks fuzzy, streaked or noisy, try adjusting the sync from this menu.

To adjust the Sync:

1.Press the menu button to display Menu 1.

2.Use the right or left arrow buttons to highlight “Sync”.

3.Press the up or down arrow buttons to adjust the Sync.

Up/Down

These functions allow you to change the vertical position of the projected image.

To re-position the display:

1.Press the menu button to display Menu 1.

2.Use the right or left arrow buttons to highlight “Up/Down”.

3.Press the up arrow button to move the image up. Press the down arrow button to move it down.

Left/Right

These functions allow you to change the horizontal position of the projected image.

To re-position the display:

1.Press the menu button to display Menu 1.

2.Use the right or left arrow buttons to highlight “Left/Right”.

3.Press the up arrow button to move the image to the left. Press the down arrow button to move it to the right.

LitePro 560/570 User’s Guide

27

Image 35

InFocus 560, 570 manual Sync, Up/Down, Left/Right

Contents

LCD Projector Users Guide Fold and tear here Page Page Certifications Declaration of Conformity Contents Do not look into the lens Safety SummaryPower Source Power Cord Hot Surfaces GroundingFuse Lamp Not shown Introduction Cables and Adapters Compatibility If You Need Assistance Remote Control Programmer KitUsage Guidelines Image Size measured diagonally Setting Up the LitePro Connecting the LCD end of the LitePro cable Connecting an IBM-compatible desktop computer Connecting a Macintosh desktop computer Connecting an IBM-compatible laptop computer Connecting a Macintosh PowerBook Connecting a Composite Video Cable Connecting an S-Video Cable Connecting the Audio from a Video Player Connecting an external speaker Connecting a microphone Setting Up the LitePro Turning the LitePro Off Using the LiteProBasic Image Adjustment Using the Remote Control Adjusting the Height Focusing the Image Switching to the Spare Lamp Switching to the Spare Lamp Menu Using the Remote Control Buttons Next Arrow buttonsSelect/enter Mic VolumePrev Mute Standby Prog Menu Using the Menus Making Changes to Menu Functions Audio MenuHighlighting Menu Functions Brightness Resetting Menu Functions to the Default SettingsMenu 1 Functions Removing the Menu from the Screen Left/Right SyncUp/Down Source Prompt Menu 2 FunctionsRear Projection Auto Standby Test PatternRS-232 Ntsc Reset Palette Source Enable Prog Button Tracking Language Video Type Text Mode and Pixel Slice Sharpness Comp Audio Menu Functions Volume and Audio Lock Balance and Fade BassTreble Loudness Cleaning the Lens Maintenance Replacing the Projection Lamps Opening the Lamp Door Bulb Guard Replacing Batteries in the Remote Control Replacing the Fuse Installing New Batteries Locating the Fuse Removing the Fuse Holder Before You Call for Assistance Troubleshooting Problem Color or VGA text not being projected Solutions to Common ProblemsProblem Nothing on screen Problem Image is out of focus Problem Image is not centered on the screenProblem Only the test pattern is displayed Problem Image is too wide or narrow for screen Problem Projected colors don’t match the monitor’s colors Problem Image and menus are reversed left to rightProblem LitePro displays vertical lines, bleeding or spots Problem Image is noisy or streaked Appendix Specifications Appendix Accessories LCD Connector Cable Connector Pin Assignments GND Monitor and VGA Connectors AST Laptop Display Activation Chart FN-F1 Appendix Assistance, see Technical Support audio Index Lite show button 22 LitePro Quadra, see Macintosh Index Limited Warranty 010-0060-05 USA