Integra DTR-6.4/5.4 Connecting the power cords from other devices, Connecting your AV components

Connecting your AV components

Connecting the power cords from other devices

The DTR-6.4/5.4 is equipped with AC mains outlet(s) for connecting the power cords from other device(s) so that their power is supplied through the DTR-6.4/5.4. By doing this, you can leave the connected device turned on and have the Standby/On button on the DTR-6.4/5.4 turn on and off the device together with the DTR-6.4/5.4.

The shape, number, and total capacity of the AC outlets may differ depending on the area of purchase.

Caution:

Make sure that the total capacity of the components connected to the DTR-6.4/5.4 does not exceed the capacity that is printed on the rear panel (e.g., TOTAL 120W).

AC OUTLET

AC 230-240V 50 Hz	AC OUTLETS
SWITCHED 100W MAX.

AC 120V 60 Hz

SWITCHED

TOTAL 120W 1A MAX.

Australian models USA and Canadian models

Connecting the auxiliary power amplifier (DTR- 6.4 only)

These jacks are for connecting an auxiliary power amplifier.

You can use an auxiliary power amplifiers to listen at louder volumes than you can with the DTR-6.4 alone. When using a power amplifier, connect each speaker to the power amplifier.

See page 17 for information regarding how to connect to a subwoofer.

				SUR
NCE	ZONE 2	FRONT	SURR CENTER SURR BACK	BAC
ER			(SB)	SPE
		L	L
		R	R
			SUB
			WOOFER

R (red)	L (white)	R (red)	L (white)	R (red)	L (white)
Front			Surround	Center	Surround back
			Power amplifier

		1	2	3	4			5	6	7
1.	Front right speaker					5.	Center speaker
2.	Front left speaker					6.	Surround back right
3.	Surround right						speaker
	speaker					7.	Surround back left speaker
4.	Surround left speaker

Note:

If you use a power amplifier connected to the SURR BACK PRE OUT terminal and connect two surround back speakers to the amplifier, set the “Hardware Config” → “b. Surr Back” setting to “2ch (PRE OUT)” (see page 32).

23