Connecting antennas
To use the tuner of the
•Adjustment and placement of the FM and AM antennas for better reception must be done while listening to a station broadcast.
•If better reception cannot be obtained, then placement of an outside antenna is recommended.
Assembling the AM loop antenna
Assemble the loop antenna as shown in the illustration.
•Refer to “Connecting the AM loop antenna” below for details on how to connect the loop antenna.
Insert into the hole
Connecting the AM antenna cable
1.Press down the lever at the antenna terminal.
2.Insert the wire into the terminal hole.
3.Release the lever.
1 | 2 | 3 |
Connecting the included antennas
Connecting the FM indoor antenna:
The FM indoor antenna is for indoor use only. During use, extend the antenna and adjust its orientation until the clearest signal is received. Fix it with push pins or similar items in the position that will cause the least amount of distortion.
If the reception is not very clear with the attached FM indoor antenna, the use of an outdoor antenna is recommended.
Connecting the AM loop antenna:
The AM loop antenna is for indoor use only. Set it in the direction and position where you receive the clearest sound. Put it as far away as possible from the
If the reception is not very clear with the attached AM indoor antenna, the use of an outdoor antenna is recommended.
FM antenna
(Indoor)
AM loop antenna
Australian models
ANTENNA | AM | FM 75 |
| ||
12 V |
|
|
|
| ZONE 2 |
TRIGGER |
| IR OUT |
|
| |
OUT |
| ZONE 2 | DC IN | LINE OUT | |
56K | 40K | ||||
|
|
| OUT | 24V 1A |
|
A | A | L |
| B |
|
USA and Canadian models
Hint:
Either of the split ends of the AM antenna can be connected to either terminal. Unlike speaker cabling, there is no polarity for AM broadcast signals.
24
