Integra DTR-6.4/5.4 instruction manual Before using this unit, Connecting the power cord, Notes

Before using this unit

Connecting the power cord

Plug the supplied power cord into this AC INLET.

•Do not use a power cord other than the one supplied with the DTR-6.4/5.4. The power cord supplied is designed for use with the DTR-6.4/5.4 and should not be used with any other device.

•Never have the power cord disconnected from the DTR-6.4/5.4 while the other end is plugged into the wall outlet. Doing so may cause an electric shock. Always connect by plugging into the wall outlet last and disconnect by unplugging from the wall outlet first.

AC INLET

Power cord (supplied)

DO NOT connect the power cord at this time.

Note:

The shape of the power cord plug will be different depending on the shipping area.

Installing the remote controller batteries

1.Remove the battery compartment cover by pressing it and sliding it in the direction shown by the arrow below.

2.Insert two AA (or R6) batteries into the battery

compartment. Carefully follow the polarity diagram

(positive and negative symbols) inside the battery compartment.

3.After the batteries are installed and seated correctly, replace the compartment cover.

1 2 3

Notes:

•Do not mix new batteries with old batteries or different kinds of batteries.

•To avoid corrosion, remove the batteries if the remote controller will not be used for a long time.

•Remove dead batteries immediately to avoid damage from corrosion. If the remote controller does not operate smoothly, remove the old batteries and replace them both with two new AA batteries.

Using the remote controller

Point the remote controller toward the remote control sensor. The Standby indicator lights up when the unit receives a signal from the remote controller.

Remote control sensor DTR-6.4/5.4

Standby indicator

30˚

30˚

Approx. 16 feet (5 meters)

Send/Learn indicator

Notes:

•Make sure that the remote control sensor is not subject to strong light such as direct sunlight or inverted fluorescent light for it may prevent proper operation of the remote controller.

•Using another remote controller in the same room or using the DTR-6.4/5.4 near equipment that uses infrared rays may cause operational interference.

•Do not put objects on the remote controller. Its buttons may be pressed by mistake and drain the batteries.

•Make sure the audio rack doors do not have colored glass. Placing the DTR-6.4/5.4 behind such doors may prevent proper remote controller operation.

•If there is any obstacle between the remote controller and the remote control sensor, the remote controller will not operate.

7