Enjoying music or videos with the
Display
Switching the display
While listening to or watching an input source, you can display the information regarding the type of source and signal being input by pressing the Display button on the
You can set separate video displays for when the input source is set to AM or FM broadcasts and for when it is set to anything else.
|
|
|
| ||
RCVR Mode |
|
|
|
|
|
CH Sel | CH |
|
| VOL |
|
Disc |
|
|
|
| |
|
|
|
|
| |
| Audio Sel |
|
| Muting |
|
| A | Angle |
| Subtitle M |
|
| TV / VCR |
| Level |
|
|
| Random |
| Audio Adjust | Level / | |
|
| Rec |
|
|
|
|
| Input Selector |
| ||
| DVD |
|
| CD |
|
| V 1 | V 2 | TAP | TUN |
|
| V 3 | V 4 | V 5 | PH |
|
|
| 1 | 2 | 3 |
|
| Pure A | Direct | Stereo |
| |
|
| 4 | 5 | 6 |
|
| SURR | THX | All ST |
| |
|
| 7 | 8 | 9 |
|
|
| DSP | DSP |
| |
Display | +10 | 0 | Search |
| |
Display | Dimmer | Zone 2 |
| ||
|
| Enter |
| ||
Temporarily changing the speaker output levels
To change the individual speaker volumes temporarily, follow the procedure given below. Each channel can be set between
Remote controller | |
| +10 |
| Display |
|
When an input source other than FM or AM is selected:
Input + volume
Program format or sampling frequency*
Input + Listening
Using the remote controller:
1.Press the RCVR Mode button.
2.Press the CH Sel button and select the desired speaker.
3.Press the Level 
or 
button to adjust the volume level.
Notes:
AngleSubtitle 
Level 
mode or Multich
*When the input signal is digital audio
The program format is displayed. For example, the display “Dolby D: 3/2.1” shows that the format is Dolby Digital with 5.1 discrete channels consisting of three front channels (front left, front right, and center), two surround channels (surround left and surround right), and the low frequency effect (LFE) channel.
When the front channel number is 2, they are the front left and front right; when it is 1, it is monaural. When the surround channel number is 1, it is monaural; when it is 0, there is no surround channel. When no LFE number is given, there is no LFE channel. Also, if there is no program format for the input signal, nothing will be displayed.
When the input signal is linear PCM
The sampling frequency is displayed. For example, the display “PCM fs: 44.1k” shows that the signal is PCM and that the sampling frequency is 44.1 kHz.
When FM or AM is selected as the input source:
FM/AM frequency +
Preset no.
FM/AM + Listening mode
•You cannot select a speaker if the configuration value of the speaker is set to “No” or “None.”
•If the speaker level is set to +1 dB or higher, the maximum level indicated on the display will change if you raise the volume level.
•When you press the Test button after you set the level, the current level will be used as the value set via the test tone.
38
