Integra DTR-6.4/5.4 Enjoying DVD multichannel audio playback, Using the tone control

Enjoying DVD multichannel audio playback

	Surround (DTR-6.4)
Direct/Pure Audio	Stereo (DTR-5.4)
(DTR-6.4)	Surround (DTR-5.4)
	Audio Adjust
	Audio Sel

Audio Selector Master Volume SURR

Stereo (DTR-6.4)

Direct (DTR-5.4)

RC-534M

CH			VOL
Disc
Audio Sel			Muting
A	Angle		Subtitle M
TV / VCR		Level
Random			Audio Adjust
	Rec
	Input Selector
DVD			CD
V 1	V 2	TAP	TUN
V 3	V 4	V 5	PH
	1	2	3
Pure A		Direct	Stereo
	4	5	6
SURR		THX	All ST
	7	8	9
	DSP	DSP	Re-EQ
+10		0	Search
Display		Dimmer	Zone 2
-- / ---			Enter

VOL

Audio Adjust

Direct

Basic operation

When you made multichannel connection (5.1ch) between your DVD player and the DTR-6.4/5.4, you can enjoy analog multichannel audio playback. Make sure that your connection is identical to the connection shown in “Connecting a DVD Player with 5.1-Channel Output” (page 20).

1.Press the DVD input source button.

2.Select “Multich” using the Audio Selector button on the front panel (or Audio Sel button on the remote controller).

DTR-6.4/5.4	Remote controller
	Audio Sel
	A

3.Turn on the connected DVD player and start playing the desired media.

4.If necessary, adjust the output level of each speaker as desired (see page 38).

Adjust the volume at each speaker so that all the volumes sound at the same level at the listening position. For the front right, front left, center, surround right, and surround left speakers, the output levels can be adjusted between –12 and +12 decibels. The subwoofer can be adjusted between –30 and +12 decibels.

5.Adjust the volume with the Master Volume dial or the VOL buttons on the remote controller.

Note:

(DTR-6.4 only) When you turn on the tone control (see the next section), the settings in “Speaker Config” and “Speaker Distance” will be used for multichannel playback.

If you change the speaker levels in step 4 above, these new levels for multichannel sources will have no effect on the settings at “Level Calibration.”

Using the tone control

To make bass and treble adjustment work for multichannel sources, you must first set the tone control to “On.”

To turn on the tone control:

1.Press the Surround button (or SURR button on the remote controller).

DTR-6.4/5.4	Remote controller
	4
	SURR

“Tone On” appears on the display and the tone control is turned on.

2.Press the Audio Adjust button and then the and cursor buttons to select Bass (or Treble).

DTR-6.4/5.4	Remote controller
	Audio Adjust

3.Press the and cursor buttons to set the desired level.

DTR-6.4/5.4 Remote controller

The Bass (or Treble) can be adjusted between –12 and +12 decibels in 2dB steps.

40