Connecting antennas
Connecting an FM outdoor antenna
Make sure to follow the general rules given below:
•Keep the antenna away from noise sources (neon signs, busy roads, etc.).
•It is dangerous to put the antenna close to power lines. Keep it well away from power lines, transformers, etc.
ANTENNA | AM | FM 75 |
| ||
12 V |
|
|
|
| ZONE 2 |
RIGGER |
| IR OUT |
|
| |
OUT |
| ZONE 2 | DC IN | LINE OUT | |
56K | 40K | ||||
|
|
|
| OUT | 24V 1A |
| L |
|
|
|
|
|
|
| |
|
|
| B |
|
|
|
|
|
|
|
|
|
|
| R |
| ZONE 2 |
|
|
|
|
| |
| VIDEO 3 | VIDEO 2 | VIDEO 1 | DVD | MO | ||
AL | IN | OUT | IN | OUT | IN | IN | OU |
Connecting an AM outdoor antenna
If reception is poor with the indoor AM antenna, stretch out the outdoor antenna (16 feet (5 meters) or more) above a window or outside.
• Keep the indoor AM loop antenna connected. Do not remove it.
Directional linkage
Do not use the same antenna for both FM and TV (or VCR) reception since the FM and TV (or VCR) signals can interfere with each other. If you must use a common FM/TV (or VCR) antenna, use a directional linkage type splitter.
To receiver | To TV (or VCR) |
Connecting the antenna cable to the 75/300 Ω antenna adapter (Australian models only)
Connecting the 300 Ω ribbon wire:
Loosen the screws on the adapter and wrap the wires of the ribbon wire around these screws. Then tighten the screws down with a screwdriver.
Outdoor antenna
300 Ω ribbon wire
Connecting the coaxial cable:
Insulated antenna cable
(Indoor)
AM loop antenna
ANTENNA | AM | FM 75 |
| ||
12 V |
|
|
|
| ZONE 2 |
IGGER |
| IR OUT |
|
| |
OUT | 56K | 40K | ZONE 2 | DC IN | LINE OUT |
OUT | 24V 1A |
A | L |
B
R
ZONE 2
| VIDEO 3 | VIDEO 2 | VIDEO 1 | DVD | M | ||
L | IN | OUT | IN | OUT | IN | IN | O |
1.With your fingernail, or a small screwdriver, press the stoppers of the 75/300 Ω antenna adapter outward and remove the cover.
2.Remove the transformer wire A from slit B and insert it into slit C.
3.Prepare the coaxial cable as shown in the diagram.
4.Connect the 75/300 Ω antenna adapter to the coaxial cable.
1.Insert the end of the cable.
2.Clamp it in place with pliers.
5.Reinstall the cover.
1 | 2 | 3, 4 |
| ✦ ✦ |
|
| |
✦ | ✦✦ | ✦✦ |
|
|
✦ | ✦ ✦ ✦ |
|
| |
| 6 | 3 | 6 | |
Slit B | mm mm mm | |||
|
|
|
| |
5/8"
(15mm)
Wire A
Slit C
25
