Integra DTR-6.4/5.4 Entering a pre-programmingcode, Learning a pre-programmingcode

Entering a pre-programming code

The remote controller has three learning functions. One is entering the pre-programmed code for a remote controller of another manufacturer. Another is the normal learning function that enables the remote controller to learn the codes directly from other remote controllers (see page 70). And the last is a macro learning function that enables you to program a series of operations into the remote controller so that the operations can all be performed at once by pressing one button.

Send/Learn indicator

RC-534M

						Buttons that can
						be preprogrammed
	CH			VOL		VOL
	Disc
	Audio Sel			Muting
	A	Angle		Subtitle	M
	TV / VCR		Level
	Random			Audio Adjust
		Rec
		Input Selector
	DVD			CD
	V 1	V 2	TAP	TUN
	V 3	V 4	V 5	PH
		1	2	3
	Pure A		Direct	Stereo
		4	5	6
	SURR		THX	All ST		Numeric keys
		7	8	9
		DSP	DSP	Re-EQ
Display	+10		0	Search
	Display		Dimmer	Zone 2
	-- / ---			Enter

Caution

With some brand’s components, some buttons may not work correctly. In this case, program the command directly from the other remote controller normally (see page 70).

Learning a pre-programming code

By entering a pre-programming code, you can have the RC-534M/ 517M remote controller operate a component made by another manufacturer. The buttons that are used for operation are given on the next page.

1.Find the 3-digit number listed for the manufacturer name of the component that you want to operate in the table on the next page.

2.Turn on the component that you want to operate (i.e. DVD, satellite tuner, or television).

3.While holding down the Mode button on the RC-534M/ 517M that you want to program, press the Display button, and then release both buttons.

The Send/Learn indicator lights when the Mode button is pressed and turns off when the Display button is pressed. When the indicator turns off, release both buttons. The Send/Learn indicator lights again.

4.Within 30 seconds, enter the 3-digit code number.

The Send/Learn indicator slowly flashes twice. If the Send/ Learn indicator quickly flashes three times, then either a mistaken 3-digit code was entered or an incorrect operation was performed. If this occurs, return to step 3.

5.Press the button that you programmed and check if the system operates correctly.

•If the component does not operate properly, return to step 3 and repeat the steps above.

•If it still does not operate properly, program the command directly from the other remote controller normally (see page 70).

When entering the code of Integra/Onkyo DVD players:

There are three SETTING numbers. Choose the SETTING number according to how you will be using the DVD player.

No. 601/613: These codes are for operating the Integra/Onkyo DVD player by pointing the remote controller directly at it, either because

it does not have an terminal, or it does but you are not

connecting it with an cable. First enter 601 and if it does not operate properly, enter 613.

No. 600: This code is for Integra/Onkyo DVD players that have an

terminal that you are connecting to the DTR-6.4/5.4 with an

cable. You will then operate the DVD player by pointing the remote controller at the remote control sensor on the DTR-6.4/5.4. You do not need to enter this code because it is factory preset. However, if the code has been changed to 601 or 613, then you will need to change it back to 600.

66