Integra DTR-6.4/5.4 instruction manual Listening to Radio Broadcasts, Tuning into a radio station

Listening to Radio Broadcasts

FM Mode Tuning /

Tuner

One of the features of the DTR-6.4/5.4 that is most frequently used is its ability to play FM and AM broadcast radio stations. The DTR- 6.4/5.4 provides a number of listening modes perfect for listening to the radio and getting the most out of your audio system. Also, by presetting radio stations that you listen to frequently, you can select

them easily by pressing the CH button on the remote controller.

Tuning into a radio station

4. Press the Tuner input source button.

Each time you press the Tuner button, the input source changes between AM and FM.

5. Using the Tuning and buttons on the front panel, tune into the station you desire.

Listening to a stereo radio station (FM mode)

When you tune into a radio station, TUNED indicator appears in the display. If you tune into an FM station in stereo, then “FM STEREO” appears. If the signal is weak, it may be impossible to tune into the station in stereo. In such a case, press the FM Mode button on the front panel. The AUTO indication disappears and the radio station is output in the monaural mode. To return to stereo, press the FM Mode button again. “AUTO” appears. Some inter-station noise may be heard, but the sound will not cut in and out as it would if stereo was selected.

Tuned in stereo

Auto mode

Band	Frequency	“FM STEREO”
		(Lights red)

•The tuner frequency changes in 100-kHz (or 50-kHz) increments for FM and 10-kHz (or 9-kHz) increments for AM.

•You can press the Tuning or button continuously for more than 0.5 seconds to scan for an FM station in the direction of the button you pressed (FM auto tuning mode). After you release the button and a station is received in stereo, the scanning stops.

42