Intel® IQ80219 General Purpose PCI Processor Evaluation Platform

Getting Started

2.6.4GNUPro GDB/Insight

2.6.4.1Communicating with Redboot

Hardware Setup:

Host with UNIX/Linux or Win32 installed

Intel® IQ80219 evaluation platform board with serial cable

Redhat Redboot monitor Flashed to the platform board

Recommended Mapping of UART Ports to Host Com Ports

Host port connected to the platform board UART.

The following communication tools can be used:

Win32 using HyperTerminal

UNIX using Kermit

Linux using Miniport

Solaris using Tip

Redboot Monitor startup:

Description: terminal emulator runs on host and communicates with the board via the serial cable.

Start: Power up the Intel® IQ80219 evaluation platform board. While the 'reset' is asserted, the two 7-segment LEDs sequentially display “88”, “A0” through “A6”, followed by “SL” (Scrub loop). When RedBoot is successfully booted, it displays the characters “A1” on the LEDs. When the final state of “A1” does not occur, reset the processor again.

The time for reset is approximately 1 or 2 seconds.

Win32 on Host Connecting with HyperTerminal.

26

Board Manual

Page 26
Image 26
Intel IQ80219 manual GNUPro GDB/Insight, Communicating with Redboot