Intel IQ80219 manual Jumper J1G2, Jumper J3E1, Jumper J3G1

Intel® IQ80219 General Purpose PCI Processor Evaluation Platform

Hardware Reference Section

3.10.9.19Jumper J1G2

Table 76.	Jumper J1G2: Descriptions
	Jumper	Association	Description	Factory Default
	J1G2	PPCI-X Reset	Can isolated the PCI-X reset from getting to the	2-3
			board.

Table 77.	Jumper J1G2: Settings and Operation Mode
	J1G2	Operation Mode
	Pins 1,2	P_RST (primary side reset) disconnected from reset circuitry.
	Pins 2,3	P_RST (primary side reset) used to reset board.

3.10.9.20Jumper J3E1

Table 78.	Jumper J3E1: Descriptions
	Jumper	Association	Description	Factory Default
	J3E1	SPCI-X Clock	Enables spread-spectrum on the SPCI-X clock.	2-3
Table 79.	Jumper J3E1: Settings and Operation Mode
	J3E1		Operation Mode
	Pins 1,2	Spread-spectrum enabled.
	Pins 2,3	Spread-spectrum disabled.

3.10.9.21Jumper J3G1

Initialization Device Select:

Used as a chip select during configuration read and write transactions on the secondary bus. Applications that do not require access to the bridge configuration registers from the secondary bus pull this pin low.

Table 80.	Jumper J3G1: Descriptions
	Jumper	Association	Description	Factory Default
	J3G1	PCI-X Bridge	S_IDSEL: Enables Bridge access from the SPCI-X side.	2-3
Table 81.	Jumper J3G1: Settings and Operation Mode
	J3G1		Operation Mode
	Pins 1,2	Uses S_IDSEL as chip select during configuration read and write transactions on the
		secondary bus.
	Pins 2,3	S_IDSEL is pulled down for application that do not require access to bridge configuration
		registers from secondary bus.

66 Board Manual