WHEELS | PROCEDURE 9 |
This Procedure Includes the Following:
Replacing Pneumatic Tires/Tubes -
Drive Wheels/Casters
Removing/Installing Drive Wheels
Removing/Installing Drive Wheel Hub
Replacing Casters
Replacing Forks
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hard- ware is tightened securely - otherwise in- jury or damage may result.
CAUTION
As with any vehicle, the wheels and tires should be checked periodically for cracks and wear and should be replaced.
REPLACING PNEUMATIC TIRES/ TUBES - DRIVE WHEELS/CASTERS
WARNING
DO NOT use your wheelchair unless it has the proper tire pressure (p.s.i.). DO NOT over- inflate the tires. Failure to follow these sug- gestions may cause the tire to explode and cause bodily harm.
If tires are pneumatic, replacement of tire or tube MUST be performed by a qualified technician.
NOTE: If drive wheels or casters are pneumatic, under- inflation causes excessive wear which results in poor per- formance of the tires.
REMOVING/INSTALLING DRIVE WHEELS
WARNING
INSTALLING.
NOTE: The keystock in the wheel hub MUST lineup with the cutout in the gearbox drive shaft.
1.Install new/existing front wheel onto the motor drive shaft. Make sure the chamfered (angled in) side of the wheel hub is pointing away from the wheelchair.
2.Install washer onto motor drive shaft.
3.Install the NEW locking tab washer onto the motor drive shaft. Make sure the locking tab is in line with the keyway of the front wheel.
4.Apply Loctite 242 to the hex screw.
5.Install the hex screw. Use a torque wrench only and torque to
Keystock
Chamfered
Side of Wheel
HubMotor
Driveshaft
Locking Tab | Keyway |
| |
Washer |
|
| Washer |
Hex Screw (Apply Loctite 242 and use a Torque
Wrench only to Torque to 90-inch pounds)
TIGHTEN Hex Screw if Locking Tab is not
Parallel with Flat on Head (STEP 9)
W H E E L S
NEVER use a locking tab washer more than once. ALWAYS use a NEW locking tab washer when installing the drive wheels.
12-inch Drive Wheel (FIGURE 1)
REMOVING.
1. The tab of the locking washer that is bent 90o up |
against the head of the mounting screw MUST be |
flattened before the mounting screw can be removed. |
Flat on Head of Hex Screw
Locking Tab Parallel
with Flat on Head of
Hex Screw (STEP 9)
Locking
Tab
2. | Removethehexscrew,lockingtabwasherandwasher |
| that secure the existing front wheel to the wheel hub. |
3. | Use a wheel puller to remove the existing front wheel |
| from the motor drive shaft. |
Bend Tab up tight against Flat on
Head of Hex Screw (STEP 10)
FIGURE 1 - REMOVING/INSTALLING 12-
INCH DRIVE WHEELS
29