Invacare Ranger IIJR Adjusting The Removable Footboard, F R O N T R I G G I N G S, Depth FIGURE

PROCEDURE 3 FRONT RIGGINGS

F R O N T

R

I

G G I N G S

5.Resecure the two (2) footboard pivots to the footboard mounting brackets with the hex screws, spacers, washers and locknuts. Refer to FIGURE 2 for the cor- rect hardware orientation.

6.Torque the two (2) hex screws to 156in/lbs. and back off the hex screws 1/8-1/4 of a revolution.

7.If necessary, reinstall the four (4) caplug caps.

ADJUSTING THE REMOVABLE FOOTBOARD

NOTE:This footboard assembly is available on models built AFTER 3/1/00. Refer to ADJUSTING THE FLIP-UP REMOVABLE FOOTBOARD for the footboard assem- bly on models built BEFORE 3/1/00 in this procedure of the manual.

NOTE: The following procedures are for both FWD and MWD fwheelchairs, unless otherwise noted.

Depth (FIGURE 3)

ADJUSTING DEPTH

Flat Head Screws

Removable

Footboard

	Mounting
	Positions
Footplate	Barrel Nut
	Barrel Nut
Clamps
	DETAIL "A"

NOTE: There is no footboard depth adjustment for 16- inch wide MWD wheelchairs.

1.Remove the four (4) flat head screws and barrel nuts that secure the removable footboard to the two (2) footplate clamps.

2.Move the removable footboard to one (1) of the four (4) positions.

Proper

Footplate

Clamp

Position for

FWD

Wheelchairs

Proper

Footplate

Clamp

Position for

MWD

Wheelchairs

NOTE: Before reinstalling the four (4) flat head screws, make sure the footplate clamps are in the proper position as shown in DETAIL "A".

3.Reinstall the four (4) flat head screws and barrel nuts that secure the removable footboard to the two (2) footplate clamps. Tighten securely.

ADJUSTING FOOTBOARD ANGLE

Angle

Removable

Flat

ADJUSTING FOOTBOARD ANGLE (FIGURE 3).

Footboard

Head

1.Loosen, butdonotremove,thefour(4)flat head screws and barrel nuts that secure the removable footboard to the two (2) footplate clamps.

NOTE: Because of the two (2) support tubes, the angle of theremovablefootboardcanbeadjusteddownwardONLY.

2.Grasp the front of the removable footboard and rotate it DOWNWARD until the desired angle is reached.

3.While holding the removable footboard in place, tighten the four (4) flat head screws and barrel nuts securely.

Screw

Footplate

Clamp	Barrel Nut
	Angle Can Be Adjusted
	Downward ONLY

FIGURE 3 - ADJUSTING FLIP-UP

REMOVABLE FOOTBOARD

16