PROCEDURE 13 | FWD WHEELCHAIRS |
F
W
D
W
H
E
E
L
C H A I R S
STEPS 2, 4, 10, 11, 12 | Spacers |
Dust Cover (Not Shown)
Battery Tray
Hanger
Bracket
Hex Screws
Footboard
Mounting
Bracket
LONG Socket Screws (Apply Loctite 242 and
torque to 60-inch pounds) (STEPS 6, 8)
Wheelchair
Frame
SHORT Socket
Screws (Apply
Loctite 242 and
torque to 60-
inch pounds)
(STEPS 6, 8)
Motor/
Gearbox
NOTE: Basic motor/gearbox shown only for clarity. Stan- dard motor gearbox reposition the same way.
NOTE: Basic motor/gearbox - It is not necessary to dis- connect clutch handle from the motor/gearbox.
FRONT MOTOR
MOUNTING POSITION
MIDDLE MOTOR
MOUNTING POSITION
REAR MOTOR
MOUNTING POSITION
FIGURE 20 - REPOSITIONING MOTORS
8.Use Loctite 242 and tighten the motor to the wheel- chair frame securely with the six (6) socket screws. Torque to
9.Repeat STEPS
10.Line up the mounting hole in the battery tray hanger bracket with the mounting hole in the wheelchair frame.
11.Left side of wheelchair only - Reinstall the front dust cover onto the end of the crossbrace.
12.Perform one (1) of the following:
A.WHEELCHAIR EQUIPPED WITH
B.WHEELCHAIR NOT EQUIPPED WITH
13.Reinstall the battery boxes. Refer to INSTALLING/RE- MOVING BATTERY BOXES in this procedure of the manual.
REPLACING CLUTCH HANDLES - R2BASIC AND R2JR (FIGURE 21)
1.Remove the battery boxes. Refer to INSTALLING/ REMOVING BATTERY BOXES in this procedure of the manual.
2.Remove the tip from the existing clutch handle.
3.Remove the pin that secures the existing clutch handle to the motor/gearbox.
4.Disconnect the existing clutch handle from the mo- tor/gearbox.
5.Feed existing clutch handle through wheelchair frame.
6.Remove the rubber tip from the new clutch handle.
7.Install the new clutch handle onto the wheelchair.
NOTE: Make sure the new clutch handle is pointing to- wards the outside of the wheelchair.
8.Install the rubber tip onto the new clutch handle.
9.Connect the clutch handle to the motor/gearbox and line up the mounting holes in the clutch handle and motor/gearbox.
10.Insert the pin through the clutch handle and motor/ gearbox as shown in DETAIL "A" in FIGURE 21.
NOTE: Make sure the detent ball on the pin is fully vis- ible.
60